E-flite 30-Amp Pro Switch-Mode BEC (V2)
This is the 30-Amp Pro Switch-Mode BEC (V2) made by E-flite.
Key Features
Up to 30 amps continuous current with proper air flow and 35 amps burst current (15 seconds)
3.5A continuous current, 5V Switch-Mode BEC Circuit
Stronger BEC for support of most 3-axis stabilization systems
Drive up to 7 analog or 6 digital standard-size servos with the BEC
3 to 4-cell LiPo, 9 to 12-cell NiMH/NiCd input voltage
Programmable motor braking
Safe power-arm mode prevents accidental starts
Programmable low voltage cutoff with settings for 3-cell LiPo (9.2V), 4-cell LiPo (12V) or 74% of battery starting voltage
Programmable throttle input range (1.1ms–1.9ms or 1.2ms–1.8ms)
Programmable soft start for helicopters and airplanes
Auto motor shut down if signal is lost or there is interference
Programmable timing—5 user-selectable ranges for use with a large variety of brushless motors
Pre-wired E-flite EC3 connector on the battery input and 3.5mm gold bullet connectors on the motor output leads
Specs
Continuous Maximum Current: 30A
Input Voltage: 3–4S LiPo or 9–12 NiMH/NiCd
Input Connector Types: 16 AWG leads with E-flite EC3 Connector
Output Connector Types: 16 AWG leads with 3.5mm Gold Bullet Connectors
Momentary Peak Current: 35A (15 sec)
Length: 51.0mm (2.00 in)
Width: 28.0mm (1.10 in)
Height: 8.70mm (0.35 in)
Weight: 31.0 g (1.10 oz)
Wire Gauge: 16 AWG
Manufacturer | E-flite |
---|---|
MPN | EFLA1030B |
UPC | 605482079164 |