E-flite 60-Amp Pro Switch-Mode Brushless ESC V2

This is the 60-Amp Pro Switch-Mode Brushless ESC V2 made by E-flite.

Key Features

Up to 60 amps continuous current with proper air flow and 75 amps burst current (15 seconds)
5A continuous current, 5V switch-mode BEC circuit (proper cooling and airflow required)
Stronger BEC for support of most 3-axis stabilization systems
Drive up to 7 analog or 6 digital standard-sized servos with the BEC on any recommended input voltage
3 to 6-cell LiPo, 9 to 18-cell Ni-MH/Ni-Cd input voltage
Finned heat sinks
Programmable motor braking
Safe power-arm mode prevents accidental starts
Programmable low voltage cutoff with settings for 3-cell Li-Po (9V), 4-cell Li-Po (12V), 5-cell Li-Po (15V), 6-cell Li-Po (18V) or 74% of battery starting voltage
Programmable soft start for helis and airplanes
Auto motor shut down if signal is lost or there is interference
Programmable timing
5 user-selectable ranges for use with a large variety of brushless motors
Utilizes new smaller MOSFET technology to minimize weight

Specs

Continuous Maximum Current: 60A
Input Connector Types: 13 AWG with E-flite EC3 connector
Output Connector Types: 13 AWG with 3.5mm gold bullet connectors
Momentary Peak Current: 15 sec @ 75A with proper cooling air flow
Length: 2.85 in (73.0mm)
Width: 1.30 in (33.0mm)
Height: 0.61 in (15.5mm)
Weight: 2.65 oz (75.0 g)